HTx213

Technical Details:
The assembly includes a Ht213 spinning rod holder and an Mx mounting system, designed for installation on the boltrope of PVC inflatables (motorboats and belly boats). The design of the holder comprises a retainer, an end limiter and a hole for a safety carabiner. The holder and a the mounting system are connected by tilt joint with 27.7° splines, complete with Dp230 7.5° splines washers, a spring, fasteners (M6*60 DIN 933 bolt and M6 DIN 985 nut) and a hex knob. The mounting kit includes two PVC elastic linings (5 mm thickness), which are equipped with 3M VHB tape. The main parts are made of fiberglass-reinforced polyamide. Fasteners and the spring — of A2 stainless steel (except for the M6 DIN 985 brass nut).



Product description:
The HTx213 kit is a simple and quick way to secure a spinning rod on a boltrope (a mounting track, which is used for fixing seats and various accessories on PVC motorboats and belly boats). There is no need for using any accessorу mount — the system installs directly at the boltrope and can be fixed in any point of it.
A universal rod holder, included in this assembly, is suitable for spinnings with a handle diameter of up to 38 mm and different types of reels: inertial, electric, multiplier, and even non-inertial.
The handle of the spinning is securely fixed with a ring retainer, which protects the tackle from falling into the water, when biting large fish and during transportation. The retainer allows for quickly releasing the spinning rod if necessary.
A stopper at the rear of the holder serves as a limiter and prevents axial rotation of the spinning rods with a cruciform slot in the end of the handle.
To maximally protect the tackle from loss, the holder has a hole for attaching a safety leash carabiner.
The design of the holder provides full control over the process of fishing and trolling: it allows for adjusting the tilt angle with 7.5° increments, you can fix the spinning rod vertically or horizontally. The selected tilt position is secured by tightening the hex knob nut.
Materials: fiberglass-reinforced polyamide, PVC, A2 (AISI 304) stainless steel, brass.
In the package: an HTx213 system, a set of PVC pads.
Tips on using & installation:
An important advantage of mounting on the boltrope is that you don't have to waste time on installation or wait for the adhesive to dry. The system can be easily dismantled without leaving marks on the surface of the vessel.
In order to minimize the gap between the mounting pad and the inflatable cylinder, elastic pads equipped with 3M VHB tape, used to get a good grip on the inflatable cylinder, are included in the assembly.
It is recommended to install the system on the half-inflated cylinder.
Despite the spline connection that is provided in the assembly, all the models designed for use on a boltrope are strongly not recommended to be supplemented with extenders, since the boltrope itself is not designed for multidirectional dynamic loads.
To prolong the service life of the product, after using it in sea water, rinse it with plenty of fresh water.